Custom Bent Ladder

 

We customize a bent ladder to fit your RV, just give us the measurements below.

 

Custom Bent Ladder

 

PLEASE NOTE: Standard ladder width is 12 inches unless otherwise stated.

 

Please provide these required measurements for the custom bent ladder below. Use the diagram on the left to locate measurements.


Measurement A1
From the bottom edge of upper mounting base to bottom edge of the lower mounting base.
Measurement A2
From the bottom edge of upper mounting base to bottom edge of the lower mounting base.
Measurement B
From the bottom edge of upper mounting base to bottom edge of the lower mounting base.
Measurement C
Measure the front edge of the handrail (point where it slopes downward) to the back edge of the handrail.
Measurement D
Align a level or board against lower portion of ladder. From center bend in ladder mark 12 inches. From this point, measure the distance from the level or board to the ladder to get measurement D.
Measurement E
Measure the distance from bend in the ladder to the bottom edge of the railing.
Measurement F
Measure the outermost edge of the ladder to the base of the mounting point.
Measurement G
Measure the length of the bottom stand-off.
Measurement H
Measure the length of the top stand-off.

 

 

 

 

 

 

Copyright SurcoInc Products. All rights reserved.