Bent Ladder Measurement Form


 

Please provide these required measurements for the custom bent ladder below. Use the diagram on the left to locate measurements.
Is this a replacement ladder? Yes No
If yes,
how many steps on ladder?		 steps
If yes,
how many stand-offs with ladder?		 stand-offs
inches
 LEFT LADDER LEG: From the bottom edge of upper mounting base to bottom edge of the lower mounting base.
inches
 RIGHT LADDER LEG: From the bottom edge of upper mounting base to bottom edge of the lower mounting base.
inches
 Measure from the top edge of the hand rail to upper mounting base.
inches
 Measure the front edge of the handrail (point where it slopes downward) to the back edge of the handrail.
inches
 Align a level or board against lower portion of ladder. From center bend in ladder mark 12 inches. From this point, measure the distance from the level or board to the ladder to get measurement D.
inches
 Measure the distance from bend in the ladder to the bottom edge of the railing.
inches
 Measure the outermost edge of the ladder to the base of the mounting
point.
inches
 Measure the length of the bottom stand-off.
inches
 Measure the length of the top stand-off.
First Name
Last Name
E-mail Address  
Phone Number
Fax Number
Special Directions


PLEASE NOTE: Standard ladder width is 12 inches unless otherwise stated.





 


© 2006 SURCO Inc. All Rights Reserved.